Art for Kids Hub How to Draw a Computer

Download Commodity

Download Article

When you're trying to describe a estimator, it'south hard to know where to starting time. Fortunately, past focusing on one part at a time, drawing a figurer is easy! First, draw the monitor. And then, sketch the keyboard for the estimator. Finish your drawing by adding the computer tower. You can also easily describe a laptop computer.

1. 1

   Start by drawing a rectangle with rounded corners. This will be the outer frame of the laptop'south screen. Make the sides of the rectangle about 2/3rds the length of the top. Draw this rectangle on the upper half of your page since the keyboard you lot'll be drawing afterward will go on the lower half.^[one]

2. 2

   Draw a smaller rectangle inside of that i. This will be the screen on the laptop. Draw it using the same proportions as the start rectangle. Leave a thin gap between the two rectangles and then in that location's a frame going around the screen.^[2]

   Advertisement

3. 3

   Sketch a trapezoid underneath the screen. A trapezoid is a iv-sided shape with just one pair of parallel lines. The top of the trapezoid will actually be the bottom of the first rectangle you drew, and so y'all don't need to draw that line. At the left end of that line, describe a straight line extending downward to the left at an angle. Do the same thing on the right finish of the top line, just have that line extend downwards to the correct. Finally, connect the ends of the 2 angled lines to close off the trapezoid.^[3]

   • Brand the trapezoid almost 2/3rds the height of the outset rectangle y'all drew.
   • This volition be the keyboard on the laptop.

4. 4

   Draw a rectangle underneath the trapezoid. The top of the rectangle will be the same line equally the lesser of the trapezoid, so yous don't demand to describe a line for the elevation. At one finish of the trapezoid, draw a vertical line extending down. Make it near 1/8th the superlative of the trapezoid. Then, practise the same thing on the right end of the trapezoid. Finally, connect the bottoms of the two vertical lines together with a horizontal line.^[4]

   • This rectangle will make the keyboard look 3-dimensional.

5. 5

   Add a smaller trapezoid inside of the start one. Make this trapezoid about ii/3rds the peak of the first one, and position it virtually the top of the first trapezoid so there's a large gap near the lesser of the keyboard. Get out a small gap between the sides and tops of each trapezoid. This is where the keys on the laptop will go.^[5]

6. half-dozen

   Make a filigree within of the smaller trapezoid. Kickoff by drawing about 10 vertical lines across the smaller trapezoid, with each line running from the summit of the trapezoid to the lesser. On the left half of the trapezoid, angle the lines to the left. On the right half, angle the lines to the correct. The center line should be perfectly vertical. Finally, draw 4 horizontal lines beyond the smaller trapezoid, with each line running from the left side of the trapezoid to the right side.^[6]

   • This grid will be the keys on the laptop.
   • To make a spacebar, erase the 3 vertical lines in the 4 squares that are centered in the bottom row and so in that location's one long key.

7. vii

   Sketch a rectangle underneath the smaller trapezoid. This will be the trackpad on the laptop. Centre the rectangle under the smaller trapezoid, and make information technology about 1/4th the length of it. Go out a thin gap betwixt the top of the rectangle and the lesser of the keys, as well as between the bottom of the rectangle and the bottom of the bigger trapezoid.^[7]

8. 8

   Finished.

   Advertisement

1. 1

   Draw a rectangle with rounded corners. This will be the outer edge of the frame that goes around the screen on the monitor. Go out enough room on your paper to describe the computer tower and keyboard.^[8]

   • If y'all want the lines on your rectangle to be as direct equally possible, draw them using a ruler!

2. 2

   Sketch a smaller rectangle inside the kickoff one. This rectangle will be the screen. Don't make it that much smaller than the first one you drew. In that location should simply exist a narrow gap between the two. The narrow gap is the frame around the screen.^[9]

   • Think to circular the corners on the second rectangle likewise.

3. three

   Describe the stand at the bottom of the monitor. Beginning, detect the center of the monitor's bottom border. And so, draw a narrow, vertical rectangle coming down off that edge. Make it effectually one/quaternary the meridian and 1/10th the width of the monitor itself.^[ten]

4. 4

   Sketch the base of the computer stand. To make the base of the stand, draw a horizontal oval that overlaps with the bottom 3rd of the stand. Brand the oval nearly 1/fifth the width of the monitor.^[11]

   Variation: You can describe a rectangular base instead of an oval 1 if you'd like. Just depict a horizontal rectangle that overlaps with the bottom 3rd of the stand.

5. 5

   Add buttons to the forepart of the monitor. To depict the buttons, sketch small-scale circles on the bottom left or right corner of the frame. Then, fill them in with your pencil. Describe effectually 2-3 buttons.^[12]

   • Try drawing buttons with different shapes if you'd like, like rectangle or square buttons!

   Ad

1. one

   Draw a long, horizontal trapezoid underneath the monitor. A trapezoid is a four-sided shape with only 1 pair of parallel lines. Brand the pinnacle and bottom lines on the trapezoid parallel. And then, depict the short lines at the ends at a 75-degree angle. This volition exist the pinnacle of the keyboard.^[13]

   • Use a ruler to draw the trapezoid if you need help making the lines straight!
   • Leave a gap between the trapezoid and the base of operations of the monitor so they're not touching.

2. 2

   Sketch a smaller trapezoid inside the first one. This is where the keys on the keyboard will go. Only brand it slightly smaller than the first trapezoid yous drew. There should only exist a pocket-sized infinite between the two shapes all the way effectually.^[14]

3. three

   Draw horizontal lines across the pocket-size trapezoid to make rows. Starting near the top of the shape, draw a horizontal line from the left side to the right side. Then, do the same thing all the style downwards the shape.^[15]

   • Be careful not to make the rows besides big or else you won't be able to fit all of the keys. Brand them narrow enough that you can fit 6-7 rows.

4. four

   Split each row into small rectangles to make the keys. Starting at the superlative row, draw vertical lines from the tiptop of the row to the lesser all the style down the length of the row. Then, motion down to the second row and repeat, only stagger the lines to create a brick-like pattern. Continue moving down the rows until you've divided all of them upwardly into individual keys.^[xvi]

   • Depict one long key near the center of the lesser row for the infinite bar.

   Tip: Y'all can label the keys with the corresponding messages, numbers, and symbols if yous'd similar!

5. v

   Depict a computer mouse next to the keyboard. To draw a reckoner mouse, first sketch an oval that's the same height every bit the keyboard. Draw a horizontal line through the centre, and so draw a vertical line from the acme of the oval to the eye of the horizontal line. End the mouse by drawing a squiggly line from the meridian of the oval to the keyboard, which will be the string.^[17]

   • Identify the mouse on either the correct or left side of the keyboard—information technology doesn't matter which side!

   Advertisement

1. 1

   Describe a alpine, vertical rectangle. This will be the forepart of the reckoner tower. Draw it on the left or right side of the monitor, and go far slightly taller than the monitor is.^[18]

2. 2

   Sketch a trapezoid on the side of the rectangle. To make the trapezoid, start by drawing a vertical line to the side of the rectangle that'due south slightly shorter than the side. So, connect the top ends of the vertical line and the side with a directly line. Do the same affair for the lesser ends. When you lot're finished, the outline of the computer belfry will look three-dimensional.^[19]

   • If you're drawing the figurer belfry on the right side of the monitor, depict the trapezoid on the left side of the tower. If it's on the left side of the monitor, draw the trapezoid on the correct side of the tower.

3. 3

   Draw two horizontal rectangles inside the vertical rectangle. These will exist where the buttons on the calculator belfry become. Identify one near the summit of the belfry and i near the heart. The size of each rectangle doesn't demand to be precise, only make each one nigh ane/tenth the height of the tower.^[xx]

4. iv

   Add buttons to the forepart of the tower. To depict the buttons, sketch evenly spaced circles downwards the length of each horizontal rectangle. Add i-3 circles per rectangle. You can likewise depict a ability push button on the front end of the tower. Just draw a pocket-size circumvolve on the lower one-half of the belfry, and then draw another circumvolve effectually it.^[21]

   Tip: Experiment with calculation dissimilar buttons to your drawing if you'd like. You can add foursquare-, rectangle-, or even triangle-shaped buttons!

5. 5

   Finished.

   Advert

Add New Question

• Question

  How can I draw a keyboard in pencil?

  

  Use your ruler or any directly edge to make the outline and keys perfectly straight. Draw lightly at first, and when you take it right, press a bit harder to darken the lines. Terminate by shading the keys and edges.

• Question

  What are the measurements of the whole cartoon?

  

  It depends on the size you have drawn it. This was nigh 3.5 inches, just you can make it whatever size you'd like it to be. It's your decision.

• Question

  Is it proficient to add together a table underneath?

  

  Certain, if you desire to create a realistic scene. But it's upwardly to y'all. If you simply want to draw a calculator, that'southward fine.

• Question

  Is it compulsory to draw a printer?

  

  No, some computers aren't connected to printers.

• Question

  Are all printers connected to the estimator?

  

  No, some are wireless while some older versions are connected with a wire.

• Question

  How practise I draw a background for the computer?

  

  Draw a line that's on all the things underneath information technology ,and it'll brand it look similar it's on a table.

• Question

  What are the unlike parts of a computer?

  

  The basic components of a computer are the monitor, the CPU (tower), mouse, keyboard, speakers (optional), and printer (optional).

• Question

  Do I take to draw the speakers and printer?

  

  That'south totally upward to you lot. It's your cartoon, then y'all can decide which details you lot desire to include.

• Question

  Tin I draw the computer on chart paper?

  

  Sure. You lot can depict it anywhere you lot want equally it is your decision. But, I think it would exist easier to draw it on a blank piece of paper as you have the freedom to draw however you desire and also you are not restricted to directly lines and squares.

• Question

  Can I color it any color I want?

  

  Of course you tin can. Macintosh used to make computers in all kinds of dissimilar colors. Besides, it's your drawing, yous should do whatever you lot want.

Show more answers

Ask a Question

200 characters left

Include your email accost to go a message when this question is answered.

Submit

Advert

Video

Thank you for submitting a tip for review!

About This Article

Article Summary 10

To draw a computer, kickoff by drawing a rectangle inside of a larger rectangle for the computer'south monitor. Make the base of the monitor by drawing a smaller square, so a rectangular base of operations. Side by side, draw a tall rectangle next to the monitor. This is the CPU, so draw in details like the CD/DVD drive and the power switch. Add in the keyboard, mouse, and other components similar speakers, then depict cords connecting all of the parts of the reckoner. To learn how to draw a printer, read on!

Did this summary help yous?

Thanks to all authors for creating a page that has been read 635,255 times.

Did this article assist you lot?

swanaccultoo.blogspot.com

Source: https://www.wikihow.com/Draw-a-Computer